If no plastic cap exists, or the plastic cap is damaged, obtain a new plastic cap and position on to the cooler line prior to the cooler line installation.Ĩ. Notice: Ensure that the cooler line being installed has a plastic cap on each end that connects to a quick connect fitting. Install the new retaining ring (E-clip) into the remaining quick connect fittings. Ensure that the three retaining ring ears are seen from inside the fitting and that the retaining ring moves freely in the fitting slots.ħ. Do not install the new retaining ring onto the fitting by pushing the retaining ring.Ħ. Rotate the retaining ring around the fitting until the retaining ring is positioned with all three ears through the three slots on the fitting.ĥ. Hook one of the open ends of the retaining ring in one of the slots in the quick connect fitting.Ĥ. Install a new retaining ring (E-clip) into the quick connect fitting using the following procedure:ģ. All retaining rings being installed must be new.Įnsure the following procedures are performed when installing the new retaining rings onto the fittings.Ģ. Install the transmission oil cooler lines to the vehicle.ĭo not reuse any of the existing oil lines or oil line fittings if there is excessive corrosion.ĭo not reuse any of the existing retaining rings that were removed from the existing quick Connect fittings. Remove the oil cooler lines from the vehicle.ġ. Disconnect the rear oil cooler lines (2) from the front oil cooler lines (1).Ģ1. Disconnect the oil cooler lines (4) from the transmission.Ģ0. Carefully lower the transmission to gain access to the cooler line fittings.ġ9. Remove the front exhaust pipe assembly.ġ7. Support the transmission with a transmission jack.ġ6. Remove the clip (2) that holds the cooler lines together.ġ4. Remove the rear sections of the cooler lines from the retainer (1) located on the right side of the engine.ġ3. Remove the front sections of the cooler lines from the vehicle.ġ2. Remove the cooler lines from the retainer (1) located on the radiator shroud.ġ1. Separate the front and rear cooler lines at the quick connect fitting (2).ġ0. Remove the cooler lines (3, 4) from the radiator.ĩ. Pull the cooler line straight out from the quick connect fitting.Ħ. Remove the retaining ring from the quick connect fitting.ĥ. Using a bent-tip screwdriver, pull on one of the open ends of the retaining ring in order to rotate the retaining ring around the quick connect fitting until the retaining ring is out of position and can be completely removed.ģ. Pull the plastic cap back from the quick connect fitting and down along the cooler line about 5 cm (2 inch).Ģ. Perform the following procedure when removing the cooler lines from the quick connect fittings.ġ. Refer to the appropriate steps when servicing individual lines. Important: The front and rear sections of the cooler lines can be serviced separately. Transmission Fluid Cooler Hose/Pipe Replacement (Body Vin Code 3) Vehicle Transmission and Drivetrain Automatic Transmission/Transaxle Fluid Line/Hose Service and Repair Procedures If you look at pics 6 and 7, you will see the clips I'm referring to.Ģ002 Chevy Truck TrailBlazer 4WD L6-4.2L VIN S They are small, hard to see, and like to fly off. Note: When you remove the retainer which holds the line on at the trans and radiator, be really careful not to lose it. The attached pics correlate with the directions. Other than that, it is going to be tight and difficult to move around under the vehicle and to guide the lines where they belong. However, I'm not sure if you have access to one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |